Daystar KT09124BK User Manual download pdf (Page 2)

Instruction Sheet P11131

2006 Daystar Products Intl

Page 2 of 4

Installation Steps

1. Read all instructions and check bill of materials and tools before beginning.

2. Disconnect the negative battery cable.

3. Place the vehicle on a clean and level surface. Set the parking brake and

place wheel chocks behind the rear wheels. Jack up the front of the vehicle

by the frame with a floor jack and support vehicle at the frame rails with ap-

proved jack stands. NEVER WORK UNDER AN UNSUPPORTED VE-

HICLE.

4. Disconnect the ABS and brake lines from the upper a-arm and spindle

( 10mm and 12mm bolts.

5. Disconnect the sway bar on both side at the spindle. ( 17mm bolt. )

6. Remove the upper strut nuts.( 14mm nuts ) You will need to reuse them later.

7. Remove upper ball joint nut ( 19mm nut ) and separate the ball joint from the

spindle by hitting the side of the spindle. DO NOT use a ball joint separator

tool it can damage the ball joint boot.

1 2 3 4

No comments

Daystar KT09124BK User Manual Page 2